I've just upgraded to V5 from V4 and I can create duplicate part numbers(not good for me)
I get a message in V4 saying that this number already exists.
Is there a setting I have forgot about to set Part numbers as unique? I can't find one.
Thanks,
Steve
By: Support
Posted on: May 13 2019 at 04:29:34 AM
Thanks Steve - I remember somebody else mentioned that a short while ago.
I don't think you can create a NEW item with a part number that already exists but it is possible to RENAME an existing item to one that already exists.
In any case I'll have a look to make sure it's in the next update.
By: Steve
Posted on: May 13 2019 at 04:37:14 AM
Yes, correct you can over right an existing part number without warning.
Very nearly caused a major issue, I had inadvertently saved new assembly with an existing number which was used in other assembly's.
Luckily just spotted it as the orders were placed, could have been costly.
Steve
By: Support
Posted on: May 13 2019 at 04:45:33 AM
An update was due for release this morning - I've pushed that back to this afternoon just to give us time to get this fix in there as well
By: IanS
Posted on: May 13 2019 at 04:46:45 AM
It's on my desk already - I just need to test it before releasing it.
By: Steve
Posted on: May 13 2019 at 04:49:38 AM
Cheers
Steve
By: Steve
Posted on: May 13 2019 at 04:53:48 AM
Can you put the latest version number on the downloads page so I don't keep having to download and see what version current is?
Cheers
Steve
By: Steve
Posted on: May 13 2019 at 06:22:51 AM
Fixed in v5.0.41.0
Reply - add a comment to this topic.
You may enter letters, numbers and standard punctuation only. HTML and other scripts/tags will be rejected.
